|
                   |
Simply Insane Our readers here at iZook come from a wide range of personalities, and they fall into (basically) four groups.
This article is about a vehicle built by someone you would expect in the fourth category. I mean, who in their right mind would try to put a Zook on a set of 49" IROKs? But Tim Terry is actually a man who talks intelligently about his creation and how he built it. When I got to the 2005 Chile Challenge (Las Cruces, New Mexico), I saw this beast on the trailer and stood there staring in awe. I have seen plenty of tube buggies built to run these trails, but none of them retained enough of the original body to make the make and model recognizable. This was the exception.
|
|||||||||
  Tim
has also incorporated 'stinger' style bars in front and back to avoid
most endo situations. He has also gone a bit extreme with the axle
upgrades... Instead of going with Toyota or Dana axles, he went
straight to Unimog portal front axles (steerable front and rear). The
lockers in this rig are set up with air actuators (not ARB) to simplify
the linkage. |
||||||||||
  The
tube front and rear clips are built with .120 wall tubing while the four
link bars are done with .250 wall. Plans are in the works to strengthen
the links even more as the need arises. Tim has also used motorcycle
turn signals up front to give the lights high visibility while
simplifying the mounting position. |
||||||||||
  There
are winches up front and out back in case he needs to help someone out
of a jam. The front winch is a Warn 8274 while the rear has a Warn 9500.
Click on the picture to the right and you will notice that this rock
crawler is registered (read street legal) as a Texas Farm Truck... |
||||||||||
  For
all the changes made on the outside of this rig the inside of the
vehicle still retains most of the original look. The first upgrade done
to the rig happened here - the stock radio was upgraded to a Sony head
unit for playing his favorite CDs out on the trail. The seats have been
replaced with something stronger (Corbeau) and the stock dash has been
refitted with a new set of guages. The shifter has been replaced with a
B&M cabled model to control the automatic transmission. |
||||||||||
  The
transfer case shifters (dual levers) look a little different, but that's
because they come up through the floor from an Atlas transfer case. Right
under the Texas Terrorist Hunting License (click through the picture on the
right) is his 15 gallon aluminum fuel cell and the Optima Yellow Top that
powers the electricals. |
||||||||||
  How
does he get those monster meats to turn you say? He dropped in the
350ci SBC from a Corvette along with the master cylinder for the
needed stopping power.
Tim says his build time was somewhere between 4-6 months. Not bad for such a short build time. Eh? If you see him wheeling around his home in Gainesville, Texas - give him a wave and a smile. |
||||||||||
|
|
||||||||||
| Built By:
Tim Terry |
02/28/07 14:59
|
|
|
