          |
 |
|
  Your
rebuild kit should include all of the main bearings as well as the needle
bearings, so remember to swap in the new components as you go. |
||
  As
you (carefully) pull the main shaft assembly apart, you will notice three
(3) ball bearings in the mix. Don't lose these. Also, don't try to remove
a component if there is a ball holding the component in place. Carefully
remove the ball and place it in the assembly order. |
||
  Once
the shaft has been disassembled, go back through the parts you have removed
and make sure you replace all of the bearings with new components that
look identical. |
||
  Then
reassemble the shaft in the reverse order that you took it apart. This is
where keeping everything in order makes the difference. |
||
 For
a reminder of the order, take a look at this.
The main bearings will need to be pressed back into place, so be careful
not to lose track of the ball bearings shown above. |
||
 |
09/15/04 14:52:21
|
|
